& MAINTENANCE MANUAL - Syracuse
TM Two Post Surface Mounted Lift MODEL CL10 200 Cabel Street, P.O. Box 3944 Louisville, Kentucky 40201-3944 * Lift capacity ratings are based on loads equally distributed on all four arms. Minimum requirements for concrete are 4 inches minimum depth, with steel reinforcement, 3500 psi ... Read Document
INSTALLATION / OWNERS MANUALS - Revolution Lift
INSTALLATION / OWNERS MANUALS Two Post Lifts 1. Any freight damage must be noted on the freight bill before signing and reported to the freight carrier with a FOUNDATION and ANCHORING REQUIREMENTS 1. Concrete shall have compression strength of at least 3,000 PSI (20684 kPa) and a minimum ... Read Document
TP9KF Two-Post Floor Plate Lift - Yahoo
TP9KF Two-Post Floor Plate Lift Surface Mounted, Two-Post, Floor Plate / Open Top Lift, Hydraulic ‘chain-over’ Drive, 9,000 lbs. FLOOR REQUIREMENTS: The lift should be installed on a 3000 PSI concrete with minimum of 4” thickness. ... Return Document
Product Manual For 2-Post Lift - Northern Tool
TWO-POST LIFT 9,000 POUND CAPACITY FLOOR PLATE Dannmar R EQUIPMENT Requirements for Operation, Inspection and Maintenance; and The Employer Shall ensure that lift defective concrete could cause lift failure resulting in personal injury or death. ... Access Content
Pro9F - Direct Lift
Pro9F 9000 lbs. Floor Plate Lift IN50019 Rev. C 03/30/2009 1 Pro9F Two Post Lifts 1. Any freight damage must be noted on the freight bill before signing and reported to the freight carrier FOUNDATION and ANCHORING REQUIREMENTS 1. Concrete shall have compression strength of at least 3,000 ... Document Retrieval
TP9KFX Two-Post Floor Plate Lift - Northerntool.com
4. FLOOR REQUIREMENTS: The lift should be installed on a 3000 PSI concrete with minimum of 4-1/4” thickness. The Floor should be level with-in gradients of ≦1/4” within area of the two columns = 135” x 18”). (See Details for Foundation Anchoring Requirements & Anchoring Tips on Page 4) STEP 2 : (Unloading & Unpacking) 1. ... View Document
4-POST LIFTS DESCRIPTION MIN. CONCRETE SPECS
4-POST LIFTS DESCRIPTION MIN. CONCRETE SPECS PL-7 7,000 lb. Capacity / Two-Post Parking Lift / Deck / Standard Rise 4 ” Min. Thickness / 3000 PSI should not be construed as actual requirements for your building, facility or application. Because local and statewide building codes may change ... Fetch This Document
Lift Install Basics - E Auto Tools
Lift Install Basics Concrete Requirements: LIFT LOCATION: Always use the architectural plans when available. Check layout dimensions against floor Two-Post Lift Models • 9K – 10K Models / $495.00 – $595.00 • 12K – 18K Models / $695.00 – $795.00 ... Fetch Content
Challenger Lifts, Inc. - McGee Company
TWO POST SURFACE MOUNTED LIFT OPERATION, INSTALLATION & MAINTENANCE MANUAL missing, note the damage or missing part(s) on the shipping papers and notify Challenger Lifts, Inc. steel reinforced concrete floor slabs, at least four inches thick. The floor should be ... Document Retrieval
BendPak XPR-10A-LP 2 Post Lift Introduction And Review ...
BendPak XPR-10A-LP 2 Post Lift Introduction and Review -EricTheCarGuy How to install a portable 2 Post Car Lift - 866-607-4022 MaxJax TWO POST LIFT // Home Garage Installation ... View Video
TWO POST LIFT INSTALLATION AND OWNERS MANUAL
Following publications supplied with this lift: • “installation and owners manual”, i man 991022 • “lifting it right”, ali sm93-1. • “automotive lift safety tips”, ali-st90. • “vehicle lifting points for frame engaging lifts”, ali/lp-guide. • “safety requirements for operation, inspection, and ... Retrieve Content
Model 165948 Two-Post Clear Floor Lift
Model 165948 Two-Post Clear Floor Lift (11000 LBS / 5000Kg Capacity) concrete, with a minimum compressive stre ngth of 3000 psi, and reinforced 165948 Two Post Lift Installation and Owners Manual 10 3. Unpack the lift. ... View Doc
concrete requirements - Rotary Lift
Concrete pad keyed under and flush with top of existing floor. ***If it is the open front columns of an SMO/ARO model must follow the two post requirements, replace concrete under each column base with a 4’ X 4’ X 6” thick 3,000psi minimum concrete pad keyed under and flush with top of existing floor. Thanks, Kelly Boldery ... Fetch Full Source
INSTALLATION AND OPERATION MANUAL - Bendpak.com
SURFACE MOUNTED TWO-POST LIFTS MODELS: XPR-12FDL XPR-12FDL-LWB that installing a lift on cracked or defective concrete could cause lift failure resulting in personal injury or death. requirements for the motor shown on the motor plate. ... Retrieve Document
TWO COLUMN AUTOMOTIVE LIFT PRO V10 10,000 POUND CAPACITY ...
TWO COLUMN AUTOMOTIVE LIFT Two Post Lifts Tighten the nut, two or three turns on average concrete (28-day cure). If the concrete is very hard only one or two turns may be required. Check each anchor bolt with torque wrench set to 85 foot pounds. ... Read Content
Septic Tank - Wikipedia
A septic tank consists of one or more concrete or plastic tanks of between 4000 and with inclusion of a lift pump. Certain septic tank designs include siphons or other devices to increase the volume and velocity of outflow system characteristics and the requirements of the relevant ... Read Article
BendPak 2 Post Lift Assembly- In Detail - YouTube
In this video I show you how I installed my BendPak XPR-10A-LP in my home shop. The lift itself is very simple. The biggest hurdle to overcome is the size and the weight of it. Once it is up and ... View Video
TP15KC-KX Two-Post Clear Floor Lift - Tuxedo Distributors
2 DEFECTIVE CONCRETE: Visually inspect the site where the lifts will be installed and check for cracked or defective concrete. 3 FLOOR REQUIREMENTS: The lift should be installed on a 3000 PSI concrete with minimum of 4-1/4” thickness. The Floor should be level with-in gradients of ≦1/4” within area of the two columns = 148” x 35”). ... Read Here
TWO POST LIFT INSTALLATION AND OWNERS MANUAL
TWO POST LIFT INSTALLATION AND OWNERS MANUAL Capacity 10,000 lbs. June 2011 IN60010 The floor on which the lift is to be installed must be 4-¼” inch minimum thickness concrete, with a mini mum compressive strength of 3000 psi, and reinforced with steel bar. • “SAFETY REQUIREMENTS ... Get Content Here
TWO POST LIFT INSTALLATION AND OWNERS MANUAL Capacity 10,000 Lbs.
TWO POST LIFT INSTALLATION AND OWNERS MANUAL The floor on which the lift is to be installed must be 4-¼” inch minimum thickness concrete, with a mini mum compressive strength of 3000 psi, and reinforced with steel bar. 4. The lifts have specific electrical requirements as described in ... Fetch Here
Automotive Lift - Derek Weaver Company
Automotive Lift. 1 W-9D Installation & Operation Manual 9000 lb. Capacity Overhead Super-Symmetric Two Post Lift Derek Weaver Company, Inc. 2944 SE Loop 820 Fort Worth, TX 76140 Failure to adhere to the specifications of concrete may result in Lift Failure. ... View Full Source
TP12KFX Two-Post Floor Plate Lift - Lib.store.yahoo.net
2. DEFECTIVE CONCRETE: Visually inspect the site where the lifts will be installed and check for cracked or defective concrete. 3. FLOOR REQUIREMENTS: The lift should be installed on a 3000 PSI concrete with minimum of 4-1/4” thickness. The Floor should be level with-in gradients of ≦1/4” within area of the two columns = 148” x 35”). ... Retrieve Here
TP9KAC / TP9KSC Two-Post Clear Floor Lifts
FLOOR REQUIREMENTS: The lift should be installed on a 3000 PSI concrete with minimum of 4” thickness. The Floor should be level with-in gradients of ≦1/4” within area of the two columns = 135” x 18”). ... Content Retrieval
No comments:
Post a Comment